Difference between revisions of "Configuring Linksys switch as radius client"
From Notes_Wiki
m |
m |
||
| Line 1: | Line 1: | ||
<yambe:breadcrumb>Freeradius configuration</yambe:breadcrumb> | |||
=Configuring Linksys switch as RADIUS client= | =Configuring Linksys switch as RADIUS client= | ||
| Line 13: | Line 14: | ||
After these the selected ports get configured for 802.1x and until authorized by RADIUS server, will not become part of network. | After these the selected ports get configured for 802.1x and until authorized by RADIUS server, will not become part of network. | ||
Revision as of 09:16, 2 December 2012
<yambe:breadcrumb>Freeradius configuration</yambe:breadcrumb>
Configuring Linksys switch as RADIUS client
To configure Linksys switches (specifically SLM224G2) as client for radius server use following steps:
- Log into switch using web administration interface.
- Go to Security -> Radius Setting page.
- Enter radius server IP address, port (default 1812 on new servers) and radius password. (assuming 'radiuspass') for this tutorial.
- Click on 'Save settings' button to save configuration
- Now go to Security -> 802.1x settings page
- Choose 'enable 802.1X' option
- Click 'Save settings'
- Now choose ports on which you want to enable 'Network Access Control'
- Now click 'Save current settings'
After these the selected ports get configured for 802.1x and until authorized by RADIUS server, will not become part of network.
