Difference between revisions of "CentOS 7.x ip command"
(Created page with "<yambe:breadcrumb>CentOS_7.x_network_management|CentOS 7.x network management</yambe:breadcrumb> =CentOS 7.x ip command= ==Add static IP to IPv4 interface using ip command==...") |
m |
||
| (4 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
[[Main Page|Home]] > [[CentOS]] > [[CentOS 7.x]] > [[CentOS 7.x system administration|System Administration]] > [[CentOS 7.x network management|Network management]] > [[CentOS 7.x ip command]] | |||
'''More updated articles on this are at:''': | |||
* [[CentOS 8.x iproute2 basics]] | |||
* [[OpenSuse Leap 15 iproute2 basics]] | |||
==Add static IP to IPv4 interface using ip command== | ==Add static IP to IPv4 interface using ip command== | ||
| Line 20: | Line 25: | ||
</pre> | </pre> | ||
==Increase priority of preferred default gateway using ip command== | |||
If there are multiple connections, eg one wireless and one wired, then we can choose preferred network (default-gateway) using ip command. For this, to check existing priorities use: | |||
<pre> | |||
ip route show | |||
</pre> | |||
To increase priority of a gateway, add it again using: | |||
<pre> | |||
ip route add default via 172.16.1.1 dev wlp3s0 proto static metric 50 | |||
</pre> | |||
Note that having two default routes for 172.16.1.1 with two different metrics is not a problem. | |||
| Line 25: | Line 43: | ||
[[Main Page|Home]] > [[CentOS]] > [[CentOS 7.x]] > [[CentOS 7.x system administration|System Administration]] > [[CentOS 7.x network management|Network management]] > [[CentOS 7.x ip command]] | |||
Latest revision as of 06:39, 25 August 2022
Home > CentOS > CentOS 7.x > System Administration > Network management > CentOS 7.x ip command
More updated articles on this are at::
Add static IP to IPv4 interface using ip command
In CentOS 7.x multiple IPv4 addresses can be associated with same interface without needing aliases (eth0:0). The older ifconfig command will show only one of these multiple addresses.
Hence use following command to check interface ip addresses:
ip addr show
Add IP to interface using:
ip address add 10.90.144.251/21 dev enp0s25
Similarly existing IP can be removed using
ip add del 10.0.0.0/21 dev enp0s25
Increase priority of preferred default gateway using ip command
If there are multiple connections, eg one wireless and one wired, then we can choose preferred network (default-gateway) using ip command. For this, to check existing priorities use:
ip route show
To increase priority of a gateway, add it again using:
ip route add default via 172.16.1.1 dev wlp3s0 proto static metric 50
Note that having two default routes for 172.16.1.1 with two different metrics is not a problem.
Home > CentOS > CentOS 7.x > System Administration > Network management > CentOS 7.x ip command
