Difference between revisions of "Setup basic 389-DS server"

From Notes_Wiki
(Created page with "<yambe:breadcrumb>389-DS|389-DS</yambe:breadcrumb> =Setup basic 389-DS server= To setup basic 389-DS server use following steps: # yum -y install epel-release # Setup remi re...")
 
m
Line 4: Line 4:
To setup basic 389-DS server use following steps:
To setup basic 389-DS server use following steps:
# yum -y install epel-release
# yum -y install epel-release
# Setup remi repository using:
#:<pre>
#::wget http://rpms.famillecollet.com/enterprise/remi-release-6.rpm
#::yum localinstall remi-release-6.rpm -y
#:</pre>
#Edit '<tt>/etc/yum.repos.d/remi.repo</tt>' and set '<tt>enabled=1</tt>'
#If LDAP server is being setup on VM or base machine then do the following: (Not useful for container based setup)
#If LDAP server is being setup on VM or base machine then do the following: (Not useful for container based setup)
##Edit '<tt>/etc/sysctl.conf</tt>'
##Edit '<tt>/etc/sysctl.conf</tt>'

Revision as of 07:31, 11 April 2015

<yambe:breadcrumb>389-DS|389-DS</yambe:breadcrumb>

Setup basic 389-DS server

To setup basic 389-DS server use following steps:

  1. yum -y install epel-release
  2. If LDAP server is being setup on VM or base machine then do the following: (Not useful for container based setup)
    1. Edit '/etc/sysctl.conf' 
      net.ipv4.tcp_keepalive_time = 300
      

      net.ipv4.ip_local_port_range = 1024 65000
    2. In '/etc/security/limits.conf' add: 
      *               soft     nofile          8192
      

      *               hard     nofile          8192
    3. Edit '/etc/profile' and at the end append 
      ulimit -n 8192
    4. Edit '/etc/pam.d/login' and after last session required line add 
      session    required     pam_limits.so
  3. Create ldapadmin user and set its password
  4. Install 389-ds and openldap-clients using: 
    yum install -y 389-ds openldap-clients
  5. Ensure that FQDN resolves to IP and with help of /etc/hosts IP resolves to FQDN. Without this setup fails. Even after setup while running the server this is necessary for server to continue working.
  6. Run 'setup-ds-admin.pl' and enter appropriate values to setup the server
  7. Allow incoming TCP connections on port 389, 636 and 9830 in firewall
  8. Configure 389-ds to automatically start on system boot using: 
    chkconfig dirsrv-admin on
    

    chkconfig dirsrv on

To connect to server on administrators machine

  1. Install 389-ds (and not just 389-console)
  2. Use command: 
    389-console -a http://<server-fqdn-or-ip>:9830/

Steps learned from http://www.unixmen.com/setup-directory-serverldap-in-centos-6-4-rhel-6-4/ and https://www.youtube.com/watch?v=2wD-u5TMsfc



<yambe:breadcrumb>389-DS|389-DS</yambe:breadcrumb>

Retrieved from "http://www.sbarjatiya.com/notes_wiki/index.php?title=Setup_basic_389-DS_server&oldid=2053"