HP cli basics
From Notes_Wiki
Home > Switch configuration notes > HP cli basics
Connect to HP switch CLI
To connect to HP switch over CLI, use:
ssh admin@IP or admin1@IP
based on whether username is set as admin or admin1.
Switch to system-view similar to enable mode
To get system-view similar to enable mode use:
system-view
See port number for given MAC address using mac address table (CAM table)
To see port number for given MAC address using mac address table (CAM table):
display mac-address AAAA-BBBB-CCCC
See port configuration
To see configuration for an interface:
display current interface Gig 1/0/34
To change interface configuration
To change interface configuration use:
interface Gig 1/0/34 shut
To quit from switch completely
To quit from switch use:
quit quit
