Configuring brocade switch for SAN zoning

<yambe:breadcrumb>Switch_configuration_notes|Switch configuration</yambe:breadcrumb>

Configure brocade switch for SAN zoning

Simliar to Configuring Cisco MDS 9124 fiber switch for SAN configuring brocade switch for SAN can be done in following steps

1. Configure aliases for all WWNs connected to brocade switch
2. Create zones with all targets and one initiator per zone.
3. Create a configuration (similar to zoneset in case of Cisco) which includes all zones

Create alias for WWN

To create alias for WWN use:

alicreate "<alias-name>", "<wwn-number>"

For example, alicreate "server2_sw2_port0", "50:00:d3:10:05:01:02:03"

'alishow' can be used see defined aliases.

Create zone using aliases

To create zone using aliases use:

zonecreate "lt;zone-name>", "<alias1>; <alias2>; <alias3>; ... "

Example: zonecreate "server2_zone", "server2_sw2_port0; storage_port1; storage_port2; storage_port3"

'zoneshow' can be used to see defined zones.

Create configuration using zones

To create configuration using zones use:

cfgcreate "<cfg-name>", "<zone1-name>; <zone2-name>; <zone3-name>; ...

Example: cfgcreate "switch2", "server1_zone; server2_zone; server3_zone ..."

'cfgshow' can be used to see defined configurations.

Save defined configuration

To save defined configuration use:

cfgsave

Enable configuration

To enable configuration (ie apply it on running switch) use:

cfgenable <cfg-name>

For example, cfgenable switch2

List WWN seen by switch

To list all WWN seen by switch use:

switchshow

See detailed port information

To see detailed information about port use:

portshow <port-number>

where <port-number> starts from 0. For example portshow 0.

<yambe:breadcrumb>Switch_configuration_notes|Switch configuration</yambe:breadcrumb>