HP cli basics
From Notes_Wiki
Home > Switch configuration notes > HP cli basics
Connect and use CLI
Connect to HP switch CLI
To connect to HP switch over CLI, use:
ssh admin@IP or admin1@IP
based on whether username is set as admin or admin1.
Shift backspace to delete characters
Instead of backspace use shift backspace to delete characters
Come directly to top
To change directly to top use Ctrl+Z
Look at existing configuration
See port number for given MAC address using mac address table (CAM table)
To see port number for given MAC address using mac address table (CAM table):
display mac-address AAAA-BBBB-CCCC
See port configuration
To see configuration for an interface:
display current interface Gig 1/0/34
See current configuration
To see current configuration (Similar to running-config in Cisco/Dell) use:
display current-configuration
See VLAN information
To see vlan information use:
display vlan brief
See routing table
To see route use:
display ip routing-table
Change configuration
Switch to system-view similar to enable mode
To get system-view similar to enable mode use:
system-view
To change interface configuration
To change interface configuration use:
interface Gig 1/0/34 shut
Note that any any point we can reset interface back to default settings using:
default
Add new static route
To add a new static route use below example:
ip route-static 0.0.0.0 0.0.0.0 192.168.7.5
To quit from switch completely
To quit from switch use:
quit quit
