Basic mdadm configuration and commands
Home > CentOS > CentOS 6.x > System administration tools > Filesystem, partition or disk related tools > Software raid configuration > Basic mdadm configuration and commands
Seeing information on running array
To see information on currently configured and running raid arrays and also status of different devices in that raid array use:
more /proc/mdstat
Creating new raid array
To create a new array we can use '-C' option to create array. We also need to specify raid level using `-l' as raid 0, raid 1, raid 5 or raid 6. We also need to specify number of devices using -n. If we are going to add only one device then we have to specify `--force' before specifing `-n 1'. At end we have to specify devices to include in the array. Example commands are:
mdadm -C /dev/md3 -n2 -l1 /dev/xvdc1 /dev/xvdd1 mdadm -C /dev/md3 --force -n1 -l1 /dev/xvdc1
Adding device to existing array
To add device to existing array we can use `-a' option. Example command is
mdadm -a /dev/md3 /dev/xxdd1
Many times adding a new device requires creation of partitions similar to existing device on new device. For this one can refer to Fdisk_or_parted wiki page. It is recommended that while adding devices to array first add the new partition which looks smaller than existing array partitions. This way if partition is too small to be acceptable, then one would get error new device is not big enough to be added. This will allow adjusting of partition sizes for next try.
Stopping running array
To stop running array we can use option `-S'. Example command is
mdadm -S /dev/md3
Creating start-up configuration from running array
To create start-up configuration of running array we can use command `mdadm --detail -sv'. To store it in startup configuration we can use shell redirection as shown in below example
mdadm --detail -sv > /etc/mdadm.conf
Using RAID device
Once device /dev/md<n> is created we can use it like normal disk device. We can either format the entire device to store some filesystem like ext3 or we can partition the device and then format the individual partitions. For some reason kernel does not reads partitions of RAID device on using `partprobe' or even with reboot. Hence it is best to format entire device and use it as single partition.
Forcing re-sync of existing array
To re-sync existing array we can call script in '/etc/cron.weekly' which re-syncs all arrays. In case we are interested in re-syncing only one array then we can use:
echo repair > /sys/block/md<n>/md/sync_action
Here <n> can be replaced by 0, 1, 2, etc. based on which device we want to re-sync. We can check what is being done on array using either 'more /proc/mdstat' or 'cat /sys/block/md<n>/md/sync_action'.
After array is re-synced the value of 'mismatch_cnt' displayed using 'cat /sys/block/md1/md/mismatch_cnt' should be zero. If this is not zero then there is some problem with re-syncing. The cron script also warns if mismatch_cnt is non-zero after re-syncing. When this happens it could be a kernel bug where re-sync is also only checking arrays. Please update kernel and reboot machine to avoid data loss..
Home > CentOS > CentOS 6.x > System administration tools > Filesystem, partition or disk related tools > Software raid configuration > Basic mdadm configuration and commands
